2K Epoxy adhesive, transparent

• The surface to be repaired must be clean, dry and free of grease. For better adhesion, roughen with sandpaper.
• Remove the syringe from the packaging and remove the plastic spatula between the pistons.
• Cut off the tip, use it later as a cap.
• Remove excess air. Squeeze out an equal amount of the compound. You can use the transparent part of the blister pack as a mixing container. After use, pull the plunger back, remove any adhesive residue and close the syringe.
• Thoroughly mix the compound for 2-3 minutes until it turns into a homogeneous mass.
• Apply the compound to the surfaces to be bonded and press lightly. Its setting occurs 5 minutes after application. Full bond strength is achieved after 24 hours.

At low temperatures, the curing time increases. Not recommended for use at temperatures above 100°C. Not suitable for bonding polypropylene and polyethylene.

Important!If as a result of storage for more than 24 months or sharp fluctuations in temperature, the compound has hardened – heat the compound before use to +60 ° C. You can use heating radiators, hot water, etc. for this. Let the compound cool down a little and it will restore its original properties.

Warning! It is forbidden to use the compound for the repair of kitchenware that is in direct contact with food!