This article explains the product’s key properties, intended use and recommended application procedure.
ML anticorrosive preservative compound
ML KERRY® KR-949 highly effective anticorrosive compound is designed to protect the hidden cavities of the car body (door bodies, sills, spars, pillars, etc.). The resulting coating perfectly protects metal surfaces from corrosion, exposure to road chemicals and aqueous salt solutions. It perfectly spreads over the surface requiring protection, forming a thin continuous film that penetrates into all the smallest cavities, displaces moisture and preserves corrosion centers. Does not flow down from vertical surfaces, does not crack. It is applied to metal, application to a rusty and damp surface is allowed. Does not affect paintwork, plastic, rubber. The operating temperature range of the protective coating is from -40°C to +80°C. Compared to an, “Anticorrosive preservative compound” has twice the fluidity, perfectly penetrates into the narrowest places, reliably protecting them. Can also be used for temporary protection of vehicle exterior surfaces. A special set of nozzles allows you to easily and quickly apply the preservative to the protected surfaces.Application
- For best results, the product should be applied at an ambient temperature of at least +10°C.
- Shake the can vigorously for at least one minute before use.
- When treating hard-to-reach cavities, use the supplied extension tube with atomizer.
- It is recommended to use “KERRY Bituminous Stain Cleaner” for removal from paintwork.
- It is recommended to allow the compound to dry for 24 hours before operating the vehicle.
View ML anticorrosive preservative compound →
KERRY® GARAGE CREW ML Cavity Wax
Anticorrosive preservative compound KERRY® KR-948 is designed for anti-corrosion protection of hidden cavities of the car body (sills, door frames, pillars, spars, interior floor, trunk, etc.). Provides temporary anti-corrosion protection of the outer surfaces of the car (bottom, sills, wheel arches, etc.). Resistant to water and aqueous salt solutions used for road treatment. The preservative can be applied to a rusty and damp surface, as well as to old anti-corrosion coatings.Application
- Protect untreated surfaces to avoid traces of aerosol.
- For best results, the product should be applied at an ambient temperature of at least +10°C.
- Shake the can well for 2–3 minutes before use.
- Apply preservative in 2-3 layers.
- It is recommended to use KERRY® Tar and Grease Remover for removal from paint coatings.
- Allow the compound to dry for 24 hours before operating the vehicle.
View KERRY® GARAGE CREW ML Cavity Wax →
Important: Read the product label and technical information before use. Test on an inconspicuous area when surface compatibility is uncertain.