KERRY Aluminum-Filled Epoxy Stick

Category: Product Q&A Tags:

This article explains the product’s key properties, intended use and recommended application procedure.

Epoxy aluminium stick

It is a two-component high-viscosity metal-polymer compound reinforced with finely dispersed aluminum powder. The special formula of the compound guarantees excellent adhesion to almost all non-ferrous metals. Epoxy Aluminium Stick KERRY® KR 115 allows you to quickly, firmly and hermetically repair a damaged product or glue the necessary elements, including those experiencing significant static and dynamic loads. Resistant to water, antifreeze, gasoline. Easy application allows you to use the compound for the restoration of fragments and reliable repair:
  • products from high-alloyed stainless steel;
  • automotive parts (aluminum and copper radiators, fasteners made of non-ferrous metals);
  • household silumin, duralumin, brass and copper products.
The mixture hardens within 15–20 minutes. at a temperature of +20°C. Operating temperature range of the repaired item is from -60°C to +150°C. Sufficient strength is achieved after 1 hour, after which the joint can be stressed, machined and painted. The product withstands prolonged freezing without losing consumer properties.

Application

  • Clean the elements to be glued from dirt and oxides with abrasive material.
  • Degrease the surface with acetone or any other compound that removes traces of oil.
  • Separate with a sharp object a part of Epoxy Stick sufficient to repair the damage.
  • Thoroughly knead until a homogeneous compound is obtained, then apply.
  • Firmly press the surfaces to be glued together.
  • At the end of work, wash your hands with warm water and soap.
  • During the curing of the compound (30-40 min.) it is not recommended to subject the repaired product to shaking and shock loads, this may affect the strength of the connection.
It is forbidden to use the compound for the repair of kitchenware that is in direct contact with food! IMPORTANT! If, as a result of storage for more than 24 months or wide fluctuations in temperature, the outer layer of cold welding has hardened, heat it up to + 60 ° C. You can use heating radiators, hot water, etc. for this. Let the compound cool slightly and it will restore its original properties.

View Epoxy aluminium stick →

Important: Read the product label and technical information before use. Test on an inconspicuous area when surface compatibility is uncertain.