- Clean the elements to be glued from dirt and oxides with abrasive material.
- Degrease the surface with acetone or any other compound that removes traces of oil.
- Separate with a sharp object a part of Epoxy Putty sufficient to repair the damage.
- Thoroughly knead until a homogeneous compound is obtained and apply to the repair site.
- Press the compound firmly against the surface to be repaired.
- At the end of work, wash your hands with warm water and soap.
- During the curing of the compound (30-40 min.) it is not recommended to subject the repaired product to shaking and shock loads, this may affect the strength of the connection.
Warning! The sealant is effective for repairing holes with a diameter of no more than 1 cm.
Important! If, as a result of storage for more than 24 months or wide fluctuations in temperature, the outer layer of cold welding has hardened, heat it up to + 60 ° C. You can use heating radiators, hot water, etc. for this. Let the compound cool down a little and it will restore its original properties.
Пока нет вопросов по данному продукту :‑(