- The surface to be repaired must be clean, dry and free of grease. For better adhesion, roughen with sandpaper.
- Remove the tubes from the packaging, open by piercing with the back of the cap.
- Squeeze an equal amount of compound from each tube. You can use the transparent part of the blister pack as a mixing container.
- Thoroughly mix the compound with a spatula to a homogeneous mass within 2-3 minutes.
- Apply the compound to the surfaces to be bonded and press lightly. Setting occurs 5 minutes after application. Full bond strength is achieved after 24 hours.
At low temperatures, the curing time increases. Not recommended for use at temperatures above 100°C. Not suitable for bonding polypropylene and polyethylene.
Important! If as a result of storage for more than 24 months or sharp fluctuations in temperature, the compound has hardened – heat the compound before use to +60 ° C. You can use heating radiators, hot water, etc. for this. Let the compound cool down a little, and it will restore its original properties.
Warning! It is forbidden to use the compound for the repair of kitchenware that is in direct contact with food!
Пока нет вопросов по данному продукту :‑(